What Is Osmosis?

Osmosis is a process of degeneration within a glass fibre laminate. It is caused by a chemical reaction between water and unreacted substances remaining in the manufactured hull. The water enters the hull through the gelcoat and once inside, reacts with the chemical components creating acidic substances.

These substances create pressure behind the gelcoat, which causes blisters and eventually cracking. Once the gelcoat is breached in this manner, the underlying laminate is capable of absorbing water like a sponge. Glass fibre boats are constructed of polyester resin strengthened by glass fibres. The glass fibre mat is soaked in the resin to form the laminate. A further polyester resin layer, called the gelcoat, provides a water barrier on the outside surface. The final structure is extremely strong but does have its problems as defects in the hull can allow water ingress into the laminate, which can cause osmosis and lead to serious structural problems. Any unprotected hull is likely to show signs of osmosis eventually like rust on a car The exact length of time before osmosis occurs depends on many factors including: the type of water in which the hull is moored, the temperature of the water and most importantly, the quality of the original hull construction.

Osmosis is not only caused by water on the outside of the hull - bilge water from the inside can also cause the problem. It is therefore worth making efforts to keep your bilges dry.

In some cases, reactive impurities in the gelcoat and laminate will cause osmosis in the earlier life of the boat. This is a structural problem and should be referred back to the boat manufacturer. Approximately 15% of osmosis cases are accounted for in this way and will normally become evident within the first three years of the boat's life.

How to Protect against Osmosis

Prevention is always better than cure and it really does make sense to protect a new boat as well as older craft. To achieve this protection it is necessary to seal the surface. This is done over the existing gelcoat.

There is no better time to apply an anti-osmosis system than before the boat has been launched. However, it must be stressed that protective systems cannot stop osmosis once it has started, or prevent it from occurring in poorly constructed hulls. It is important that a full check is undertaken before starting.

Coating method - Epoxy barrier coats applied in one day to ensure chemical bond between each coat.